16
LI0083 – Revision 22 June 2017
Special Responses
Reset<crlf>
submitted when 12AU is powered on.
OVL_on<crlf>
submitted when
OVL
is received or in message mode
when conditioning amplifier overload status changes. It
reflects the overload status.
OVL_off<crlf>
see
OVL_on<crlf>
.
SOVL_on<crlf>
submitted when
SOVL
is acquired or in message mode
when speaker voltages overload status changes. It
reflects the overload status.
SOVL_off<crlf>
see
SOVL_on<crlf>
.
COVL_on<crlf>
submitted when
COVL
is acquired or in message
mode when speaker amplifier current overload status
changes. It reflects the overload status.
COVL_off<crlf>
see
COVL_on<crlf>
.
MOVL_on<crlf>
submitted when
MOVL
is acquired or in message mode
when Monitor rear output overload status changes. It
reflects the overload status.
MOVL_off<crlf>
see
MOVL_on<crlf>
.
Overload Response in Latch Mode
For each of the overload detectors, an internal overload status flag is reflecting the actual over-
load condition. The overload status flag will be set when an overload occurs.
In latch mode, the status flag and the LED will be set by an occurrence of overload. It can only be
reset after the overload condition has been removed and the overload status is read by sending
the
OVL<cr>
command (
SOVL
,
COVL
or
MOVL
respectively).
Note:
The command:
OVLLED N<cr>
will disable the conditioning amplifier’s overload LED, the
behavior in all other ways is unchanged.
Note:
the Monitor rear output has no overload LED indication, it can only be read via the USB
interface.
