www.g-lites.com
14
Occupation of the DIP-switches (8-bit-mode):
Setting the DMX
Starting address:
DIP-switch no.
1
2
3
4
5
6
7
8
9
Projector number
& channels
DMX-starting
address:
1
2
4
8
16
32
64
128 256
Device 1-channels 1-8
ON
OFF
Device 2-channels 9-16
ON
OFF
Device 3-channels 17-24
ON
OFF
Device 4-channels 25-32
ON
OFF
Device 5-channels 33-40
ON
OFF
Please note that the projector can also be operated in 16-bit-mode. In the 16-bit-mode, the
projector occupies 10 control channels. The projector can be switched to 16-bit-mode via the
Function-DIP-switches.
Controlling:
After having addressed all this moving-head light, you may now start operating these via
your lighting controller.
Note:
After switching on, the moving-head light will automatically detect whether DMX-512 data is
received or not. If the data is received, the display will show “A001”with actually set address
and the DMX-LED is lit. If there is no data received at the DMX-input, the DMX-LED is off.
This situation can occur if:
-The 3 PIN XLR plug (cable with DMX signal from controller) is not connected with the input
of the moving-head light.
-The controller is switched off or defective, if the cable or connector is defective or the signal
wires are swap in the input connector.
