www.g-lites.com
13
Caution: At the last fixture, the DMX-cable has to be terminated with a terminator. Solder a
120 resistor between signal (“C”) and signal (+) into a 3-pin XLR-plug and plug it in the DMX-
output of the last fixture.
5
.
5 Connection with the mains
Connect the device to the mains with the enclosed power supply cable.
The occupation of the connection-cables is as follows:
The earth has to be connected!
Lighting effects must not be connected to dimming-packs.
6
.
OPERATION
After you connected the effect to the mains, this moving-head light starts running. During the
reset, the motors are trimmed and the device is ready for use afterwards.
You can control the projectors individually via your DMX-controller. Every DMX-channel has
a different occupation with different features. In order to call up the different features, you first
have to open the shutter (control channel 4, DMX-value 241-255).
Turn the focus-screw next to the objective-lens for adjusting the focus in order to obtain a
sharp projection.
6
.
1 Addressing
Each projector occupies 8 channels (8-bit-mode). To ensure that the control signals are
properly directed to each projector, the projector requires addressing. This is to be done for
every single projector by changing the DIP switches as set out in this table.
The starting address is defined as the first channel from which this moving-head light will
respond to the controller. If you set, for example, the address to channel 6, the moving-head
light will use the channel 6 to 13 for control.
Please make sure that you don’t have any overlapping channels in order to control each
moving-head light correctly and independently from and other fixture on the DMX data link. If
two, three or more moving-head light is addressed similarly, they will work similarly.
Cable
Pin
International
Brown
Live
L
Blue
Neutral N
Yellow/Green Earth