Section 50
00-02-1031
2019-08-07
- 34 -
Display Board Status Screen
The user may view diagnostic information that reflects the
operating conditions of the display only.
a) Backlight -
Adjust the value from 0 (OFF) to 100 (Full
ON) percent to modify the intensity of the backlight. NOTE:
This value changes in real-time as adjustment are being
made. Pressing ESC will NOT discard the changes made
to this value. A password is not required to change this
setting.
b) DSP Contrast -
Adjust the value from 150 to 180 to
modify the LCD contrast. As the number is increased the
active pixels of the display will become darker. Increasing
the contrast too much may also increase the darkness of
the background. NOTE: This value changes in real-time as
adjustment are being made. Pressing ESC will NOT
discard the changes made to this value. A password is not
required to change this setting.
c) System Volts -
Indicates internal voltage measurement
of display VDC input.
d) PCB Temperature -
Indicates internal temperature
measurement of display. This is used primarily to monitor
ambient temperature to operate LCD heater.
e) Heater PWM % -
Refers to the LCD heater which only
operates in cold temperature conditions.
f) Reset Source -
Indicates the cause of the last reset.
Possible causes include external reset, power-up, brown-
out and watch dog.
