30
Initial Set-Up
2. Modulation Mode Check
The T3PK transmitter output signal format can be
changed to match the type of receiver. Check if the
modulation mode is set to match the receiver used.
When using an FM receiver (e.g., R133F), the modula-
tion mode must be set to PPM. When using a PCM re-
ceiver (e.g., R113iP), the modulation mode must be set
to PCM. When using a H.R.S receiver (e.g., R203HF),
the modulation mode must be set to HRS. If this setting
is incorrect, change it with the HRS/PCM/PPM Select
(page ) function.
(PPM)
3. Trims Initial Set-Up
- Steering trim (DT1) check
At initial set-up, steering trim is assigned to digital trim
DT1 above the steering wheel. Operate the DT1 lever
and check if the steering trim display on the screen
changes. After checking the trim, set the trim display to
the center (N) position.
- Throttle trim (DT2) check
At initial set-up, throttle trim is assigned to digital trim
DT2 at the left side of the steering wheel. Operate the
DT2 lever and check if the throttle trim display on the
screen changes. After checking the trim, set the trim
display to the center (N) position.
