51
<Functions of Linkage Menu>
S1
<Edit dial>
● Select the function name
and return to the Linkage
menu by pushing the RTN
button or pushing the
Home/Exit button.
MODEL SELECT
The Model Selection function performs model addition, call,
deletion, copy, and model name setting.
This function is used to load the settings of the
desired model into the FMT-03’s memory.
The settings may be selected from either the
transmitter’s built-in memory or a micro SD card.
Remember that up to 30 model memories are
available in the transmitter.
The name of the model stored in the transmitter
and the micro SD card may be changed. This can
be very useful to tell different models settings apart.
Each model name can be as long as 15 characters,
and the model name always appears in the display
screen. The Copy function is used to copy one set
of model data into a second memory within the
transmitter and the micro SD card. It may be used
for getting a head-start on setting up models with
almost the same settings (only differences need to
be modified, instead of entering the complete model
from scratch). Also, this function may be used to
make a backup copy of a model setup before any
changes are made.
Model call
*Model data saved at models other than the model currently
used or saved on a Micro SD card can be called.
1. Use the edit dial to move to the save
destination ("INTERNAL" or "MEM.CARD") and
push the RTN button to switch to the data
input mode.
Select the location which is to save the
desired model by turning the edit dial to the
left or right. Push the RTN button.
[INTERNAL]: Transmitter memory
[MEM. CARD]: Micro SD card
2. After using the edit dial to move the cursor to
the desired model in the model list, push the
RTN button.
3. Use the edit dial to move to [SELECT].
4. Push the RTN button. When a confirmation
message is displayed and the RTN button is
pushed again, calling is complete.
*Transmission stops and a send with new model confirmation
message ("TRANSMIT?") appears.
5. To start transmission, use the edit dial to
select [YES] and then push the RTN button.
To not transmit, select [NO] and push the RTN
button.
Model addition
*A new model can be added to the transmitter memory or
Micro SD card.
1. Use the edit dial to move the cursor to the
save destination ("INTERNAL" or "MEM. CARD)
and push the RTN button to switch to the
data input mode.
Select the save destination by turning the
edit dial to the left or right. Push the RTN
button.
[INTERNAL]: Transmitter memory
[MEM. CARD]: Micro SD card
2. Use the edit dial to move to [NEW].
3. Push the RTN button. A confirmation message
appears. Push the RTN button again.
*The model type setup screen and frequency setup screen are
automatically displayed. Confirm or change the model type
and frequency.
*A starting transmission with new model confirmation
message ("TRANSMIT") appears.
4. To start transmission, use the edit dial to
select [YES] and then push the RTN button.
To not transmit, select [NO] and push the RTN
button.
*The added model appears in the model list.
● Select [MODEL SELECT] at the linkage menu and call the
setup screen shown below by pushing the RTN button.
*The display screen is an example. The screen
depends on the model type.
(Model list)
●"Save to"
[INTERNAL]: transmitter memory
[MEM.CARD]: Micro SD card
Scrolling
● Moving cursor
● Selecting mode
Summary of Contents for FMT-03
Page 1: ...1M23Z04404 For model...
