FUTABA FMT-03, Instruction Manual

Page: 10 / 68

10 <Introduction>
Never disassemble or modify the micro SD
Card.
Do not unreasonably bend, drop, scratch or
place heavy objects on the micro SD Card.
Since the micro SD Card is an electronic
device, be careful of static electricity.
■ Static electricity may cause erroneous operation or
trouble.
Do not use the micro SD Card near radio and
television sets, audio equipment, motors and
other equipment that generate noise.
■ Doing so may cause erroneous operation.
Do not store the micro SD Card in the
following places:
・ Where the humidity is high
・ Where the temperature difference is severe
Micro SD Card (Commercial Product) Handling Precautions
WARNING
CAUTION
*Read the instruction manual supplied with
the micro SD Card for details.
●Recorded data
The data recorded on the micro SD Card cannot be
compensated regardless of the contents or cause of
the trouble or obstruction.
Futaba does not perform data restoration or recovery
work.
If smoke or an abnormal odor emanates from
the card, immediately turn off the transmitter
power.
Do not use the Micro SD Card where it may be
exposed to water, chemicals, oil, or other fluids.
■ Doing so may cause a fire or electric shock by short
circuit.
・ Where it is very dusty
・ Where the card will be exposed to shock and vibration
・ Near speakers and other magnetic devices
Do not expose the card to shock and vibration
and do not remove the card from the card slot
while data is being written or read.
■ The data may be damaged or lost.
Keep wireless equipment, batteries, aircraft,
etc. away from children.
Storage and Disposal Precautions
WARNING
Do not store wireless devices in the following
places:
・ Where it is extremely hot (40 ℃ [104F] or higher) or
cold (-10℃ [14F] or lower)
・ Where the equipment will be exposed to direct
sunlight
・ Where the humidity is high
・ Where vibration is prevalent
・ Where it is very dusty
CAUTION
・ Where the device may be exposed to steam and heat
When the device will not be used for a long
time, remove the battery from the transmitter
and aircraft and store them in a dry place where
the temperature is between 0 and 30℃ [32F and
86F].
■ Left standing 'as is' may will cause battery
deterioration, liquid leakage, etc.
Do not directly expose plastic parts to fuel, oil,
exhaust gas, etc.
■ If left in such an environment, the plastic may be
attacked and damaged.
■ Since the metal parts of the case may corrode, always
keep them clean.
Always use genuine Futaba products such
as transmitter, receiver, servo, FET amplifier,
battery, etc.
Other Precautions
CAUTION
■ Futaba is not responsible for damage sustained by
combination with other than Futaba Genuine Parts.
Use the parts specified in the instruction manual and
catalog.
This product SHOULD NOT been used for the
devices that is directly related to human life and/
or harmful devices for human body such as below
applications.
(1) Medical Devices
(2) Aerospace/Aviation Related Devices
(3) Nucleated Devices e.t.c.