56
<Functions of Linkage Menu>
S1
<Edit dial>
● Select the function name
and return to the Linkage
menu by pushing the RTN
button or pushing the
Home/Exit button.
FUNCTION
Channel assignment of each function can be changed.
Function change
1. Use the edit dial to move the cursor to the
"FUNCTION" item of the channel you want to
change and push the RTN button.
*The function selection screen is displayed.
2. Use the edit dial to move the cursor to the
function name you want to set and push the
RTN button.
*The function name blinks.
3. Push the RTN button to execute the change.
(When you want to cancel this operation,
operate the edit dial or S1 button.)
*Multiple channels can be assigned to one function.
Operation control change
1. Use the edit dial to move the cursor to the
"CONTROL" item of the channel you want to
change and push the RTN button.
*The control selection screen is displayed.
2. Use the edit dial to move the cursor to the
control you want to change, and push the
RTN button.
*The same control can be assigned to multiple channels.
*The setting can be changed for each condition.
After the set mode is changed from group mode [G] to
single mode [S] at the control selection screen, only that
condition setting is changed by control change; setting of
other conditions remains the same.
(The display screen is an example. The screen
depends on the model type.)
● Select [FUNCTION] at the linkage menu and call the
setup screen shown below by pushing the RTN button.
● Trim operation mode
"COMB": Combination mode
"SEPAR": Separate mode
When you select model and wing (swash) types,
you will find that the optimized combinations of
servo output channels and functions have been
already preset. If you would like, you can freely
change combinations of servo output channels,
functions (aileron, elevator, etc), and control (sticks,
switches, and trim levers).
*You can also assign the same function to multiple servo
output channels such as assigning elevator function to CH2
and CH3.
Channel Replacement
When the channel is replaced in the function
menu, replaced channel uses the setting data (End
point, SUB-TRIM, REVERSE, F/S, and B-F/S,
etc.).
Servo Output Channels
For FASSTest 12CH mode, you can set 12 linear
channels and two digital channels. For FASSTest
18CH mode, you can set 16 linear channels and
two digital channels.
*DG1/2 (digital channels)
These channels can function as switched channels. You can
freely change combinations between servo output channels
and input controls (sticks, switches, and trim levers).
Motor Function
If you have either a glider or airplane model type
selected, and choose to activate the motor function,
a reverse setting screen is displayed.
*If "YES" is selected, the output is reversed. If "NO" is
selected, the output is normal.
Scrolling
● Moving cursor
● Selecting mode
● Push the S1 button
to call next page.
Summary of Contents for FMT-03
Page 1: ...1M23Z04404 For model...
