Ver.1.1
29
DAS (Show/set the destination address)
[Format]
DAS (setting value)
setting value: 000 to 255
[Response]
xxx: Current address (in case of address referencing)
P0: Normal end (in case of address setting)
N0: Co mmand error
[Function]
- This command shows and/or sets a the destination address of headerless packet transmission mode.
- When this command is entered without any setting values, the FDP02 returns current destination address.
If setting value (new address) is put after DAS command, the destination address of the FDP02 is changed
to new one.
- Setting of a new address with by this command is only temporary. If the FDP02 is reset by RST
command or initialized, the destination address is returned to the address that is defined by REG02.
[Examples of use]
>@DAS<Cr><Lf>: Show current destination address
<003<Cr><Lf>:
Current destination address is “003”.
>@DAS001<Cr><Lf>: Set the destination address to “001”.
<P0<Cr><Lf>:
The destination address is changed normally.
