Model # and model name cur-
rently operating
Model # and model name to be
modified
Model #.
M1~M40
Modified model # and model
name
Model selection set button
- (+) and (-) buttons pressed
simultaneously for about 1 sec-
ond.
Model selection button
- Select the model by (JOG) button
up, down, left, or right operation.
100
Fu
n
c
tio
n
(Opening Screen)
MENU 1
Press t
he
button
Calling the setup screen
(Opening Screen)
MENU 2
DIRECT SEL
*Calling from menu screen
Press the button set
at this function.
MENU1/2 selection
by
button
Menu screen call
by
button
Select the function
by
button
Press t
he
button
* W h e n t h e d ire c t c all but to n
is set, the setup screen is also
called by the following method:
When the type was changed to a different model, signals are
output by previous model type until the transmitter power is
turned off. Use after turning the transmitter power off and on.
When changing the receiver type and servo response to a dif-
ferent model (FASS-C1, FASST-C2, or HIGH SPEED, NORMAL)
Model Selection "M-SEL"
Forty model data (model data for 40 R/C cars) can be saved in the 4PKS transmitter and
used when the relevant model data is called.
Select the model # by (JOG) button
Current model # and model name
Model Selection "M-SEL"
1
(Model No. selection)
Select the model No. by (JOG) button up, down, left, or right
operation.When the up (JOG) button is operated from the
"M1" ~ "M5" cursor position on
the top line or the down (JOG)
button is operated from the
"M16" ~ "M20" cursor posi-
tion on the bottom line, "M21"
~ "M40" is displayed. Perform the same operation to display
the model numbers "M1" ~ "M40" from "M21" ~ "M40".
2
(Model selection execution)
Press the (+) and (-) buttons
simultaneously for about 1
second. A beeping sound is
generated and the model is
selected.
- Model selection is complete when the model No. and model name at the
bottom left of the screen change.
3
When ending setting, return to the initial screen by pressing
the (END) button twice (for function menu screen, press the
(END) button once).
Using the model selection function
