Normal condition
2nd condition
Normal condition
2nd condition
Copy
Abbreviation used on menu screen
Function name, etc
D/R
Dual rate function
ATL
ATL function
STEXP
Steering EXP
THEXP
Throttle EXP (Forward side) EXP & VTR (not CRV)
STSPD
Steering speed TURN & RETURN side
THSPD
Throttle speed SPEED-LOW, MID, HIGH
A.B.S
2CH A.B.S. function ABS-ABP, ABS-DLY, ABSCYCLE
BRAKE
Brake mixing (3CH,4CH) BRK-RATE, ABS-ABP, ABS-DLY
PMIX1
Program mixing 1 RGHT/BRAK/DOWN sides, LEFT/FWRD/UP sides
PMIX2
Program mixing 2 RGHT/BRAK/DOWN sides, LEFT/FWRD/UP sides
Related function
113
Fu
n
c
tio
n
System Functions "SYSTM"
Set second condition function (2ND COND)
Two kinds of data can be set in one model for specific functions only. For example, two
kinds of data such as steering D/R set to 90% at normal condition and steering D/R set
to 80% at second condition. This second condition can be set for each model.
- To use the second condition function, setting "2ND-COND" to ACT (active) by "SYSTEM" and
switch setting by function select switch (page 88) are necessary.
- Switching from normal condition to second condition by switch set by function select switch is
indicated by an audible alarm.
- When switched to the second condition side, the LED blinks (does not blink when "LED-MODE"
setting by "SYSTEM" is OFF), and
is displayed on the initial screen and menu screen and
the screen of the functions for which second condition can be set. When switched from second
condition to normal condition, an audible alarm sounds and the
display disappears.
- After "2ND-COND" was set to ACT (active) by "SYSTEM" and switch setting was performed by
function select switch (page 86), all the normal condition data is copied to second condition only
when initially switched from nor-
mal condition to second condi-
tion by switch. Thereafter, normal
condition and second condition
can each set two kinds of data.
The items which can be set by
second condition are reverse displayed.
- Each data set by second condition is memorized until "2ND-COND" is changed to the INH (inhibit)
state by "SYSTEM", or the data
is reset by model setting (page
102). The data is memorized
even if switch setting by function
select switch is performed.
