123
Refer
e
nce
Reference
Ratings
Transmitter T4PKS
(Wheel system, 4 channels)
- Transmitting frequencies 2.4GHz band
- Futaba FASST-C2(R614FF, R604FS/FSE), FASST-C1(R603FS/FF)
- Power requirement
(Ni-MH battery) NT5F1700B Ni-MH battery (6V)
(Dry cell battery) Penlight x 4 (6V)
- Current drain 250mA or less (Vibration and back lighting off)
- Transmitting anntenna 1/2
λdipole
Receiver R614FF
(4 channels receiver)
- Receiving frequencies 2.4GHz band
- Power requirement Rated voltage :3.7V~7.4V / Usable voltage :3.5~8.4V
The voltages given above are for the R614FF. Actually, since the power supply is shared
with the servo, use a power supply that takes into account the servo ratings.
- Current drain 135mA or less
- Size 35.1x23.2x8.5mm (1.38x0.91x0.33in)
- Weight 7.8g (0.27oz)
*Specifications and ratings are subject to change without prior notice.
ｎ
Caution
ｊ
When using the T4PKS in the high speed (HIGH SPEED) mode, always use it under the follow-
ing conditions:
Servos
:Futaba digital servo (including BLS Series brushless servos)
Receiver’s battery :Matched to the ratings of the receiver and connected digital servo (dry cell battery cannot be used).
Transmitter mode :HIGH SPEED mode (See page 46 for setting method.)
Under other conditions, the set will not operate, or the specified performance will not be displayed even if it operates.
In addition, it may cause servo trouble. Futaba will not be responsible for damage, etc. caused by combination with the
products of other companies.
In addition, the FSU1 Fail Safe Unit cannot be used because the system is different. Use the fail safe function of the
transmitter.
ｊ
When using analog servos, always switch the T4PKS servo response to the NORMAL mode.
Transmitter mode :NORMAL mode (See p.46 for setting method.)
Receiver’s battery :Matched to the ratings of the receiver and connected digital servo.
The set cannot operate in the HIGH SPEED mode. Operation in this mode will cause trouble with servos and other equip-
ment. Digital servos (including BLS Series brushless servos) can also be used in the NORMAL mode.
