17
Changing Modes (
TX SETTING
):
Hold down
MODE
and
END
keys while turning on the transmitter to call
TX SETTING
menu.
Stick Mode
: The screen reads "
STK-MODE
". Change this to the correct mode. Note that this will
NOT change the throttle and elevator rachets, etc. Those are mechanical changes that must be
done by a service center.
Throttle Reverse
:
THR-REV
is a special function that reverses the entire throttle control, including moving the trim
functionality to the Stick’s upper half. To use
THR-REV
,
CURSOR DOWN
to
THR-REV
and turn the
DIAL
to
REV
. Turn the
transmitter off and back on. This change affects all models in the radio.
Display language
: can be selected the display language of the function name, etc. in each function menu. The screen reads
"
LANGUAGE
". Change this to the desired language.
TM-10 Area Selection (Frequency Range)
(TM-10 module only):
The TM-10 transmitter module has been designed to function in many countries. If you will be utilizing this module in a
country other than France, please make sure that
TM10-MODE
is set to "
GENERAL
". If, however, this module will be utilized
in France, it must be set to "
FRANCE
".
[Note] While changing the above modes, the transmitter transmits in
PPM
mode even if the set-up mode is
PCM
mode and
the RF power is turned off when using a TM-10 module.
Power Down mode (
TM10 POWER MODE
) (
TM-10 module only
):
We have installed a special "Power Down Mode" for doing a ground range check. Hold down
DIAL
while turning on the transmitter to call
TM10 POWER MODE
menu.
Power Down Mode
: To activate the "Power Down Mode" press
DIAL
and the home screen will appear. During this mode,
the RF power is reduced so the range test can be performed. In addition, when this mode is activated the blue LED on the
front of the transmitter starts blinking and the transmitter gives users a warning with a beep sound every 3 seconds.
The "Power Down Mode" continues for 90 seconds and after that the power will go back to the normal level. To exit the
"Power Down Mode" before the 90 seconds, press
DIAL
again. This mode is available 1 time only so if you need to re-use
this function the transmitter power must be cycled.
NEVER
VWDUWÀ\LQJZKHQWKH3RZHU'RZQ0RGHLVDFWLYH
Power Off Mode
: To use the RF power off mode,
CURSOR DOWN
to
OFF
and press
DIAL
. During this mode, the RF
power is turned off. The blue LED on the front of the transmitter is turn off.
CAMPac Initializing Method and Data Conversion (T9C/T9CS to T10C):
Insertion of a new CAMPac or a CAMPac containing data of a different transmitter type will
open
EXT-MEMORY
menu after turning the transmitter on.
To initialize the CAMPac,
CURSOR DOWN
to "Yes" and press
DIAL
and the check display of "OK?" will appear. Press
DIAL
again, the initializing of the CAMPac will start.
7RFRQYHUWWKH&$03DFGDWDIURP7&7&6WR7&VHOHFWWR1RE\
CURSOR
lever and then press
DIAL
and the
home screen will appear. See p.30 for the conversion method.
