13
NOTE: If you need to remove or replace the transmitter
battery, do not pull on its wires to remove it. Instead,
JHQWO\SXOORQWKHFRQQHFWRUVSODVWLFKRXVLQJZKHUHLW
plugs into the transmitter.
Battery connector location
Charging jack
RF module
Trainer function
/DSC function
connector
Battery cover
NT8S
Ni-Cd battery
pack
Attachment of the Module
CAUTION
Be sure to turn off the power of the transmitter before
you install or replace the module.
To remove, press the tabs together and gently pull
rearwards. To install, line up the connector pins with
the socket in the rear of the module and gently snap
into position.
SWITCH ASSIGNMENT TABLE
• The factory default functions activated by the switches and knobs for a 10CA Mode 2 transmitter are shown below.
• Most 10C functions may be reassigned to non-default positions quickly and easily.
• Basic control assignments of channels 5-10 are quickly adjustable in
AUX-CH
(see p. 46). For example, the channel 5
servo, which defaults to
SWITCH E
for retract use, can easily be unassigned (NULL) to allow for easy use as a second
rudder servo in a mix, or to a slider or dial for bomb door or other control.
• Note that most functions need to be activated in the programming to operate.
• 10CA Mode 1, 10CH, and 10CP transmitter functions are similar but reverse certain switch commands. Always check
that you have the desired switch assignment for each function during set up.
Switch/Knob
A or H
Airplane (
ACRO
)
Sailplane/Glider (
GLID
)
Helicopter (
HELI
)
SWITCH A
elevator dual rate
ch10
elevator dual rate
GRZQ EXWWHUÀ\RQ
ch10
elevator dual rate
ch10
SWITCH B
rudder dual rate
ch9
rudder dual rate
ch9
rudder dual rate
ch9
SWITCH C
up =
ELE-FLP
on
FHQWHUGRZQ
IDLE-DOWN
down =
AIRBRAKE
on
up =
ELE-FLP
on
center = Distance cond.
down = Landing cond.
governor
SWITCH D
aileron dual rate
aileron dual rate
aileron dual rate
SWITCH E or G*
ODQGLQJJHDUFK
WKURWWOHKROGFK
SWITCH F or H*
VQDSUROOWUDLQHU
trainer
WUDLQHU
THR-CUT
SWITCH G or E*
none
up = Speed cond.
down = Start cond.
idle-up 1 and 2
SWITCH H or F*
none
LGOHXSJ\UR
KNOB A
ÀDSFK
ÀDSWULPLI
FLAPERON
on)
ÀDS
ch6
HOVERING PITCH
KNOB B
ch 8
ch 8
ch 8
KNOB C
VSRLOHUFK
(disabled if
AIL-DIFF
on)
ch 7
(disabled if
AIL-DIF
on)
HOVERING THROTTLE
ch7
SLIDER D
none
ch 5
none
SLIDER E
none
none
HI-PIT
*On the 10CA Mode 2 transmitters, the TOP LEFT
SWITCHES
are spring-loaded and 2-position; on the 10CA Mode 1, 10CH, and 10CP, those
switches are on the right side. For consistency, the switch position’s designation remains the same (upper left is F, etc), but the functions are moved to
match the switch type.
