Furuno TZT16F, Installation Manual

Page: 32 / 67

2. WIRING
2-6
2.8.1 How to connect the TZT16F to CAN bus equipment
Below is an example of two units, connected via CAN bus to CAN bus sensors.
2.8.2 How to connect Yamaha engine(s)
When interfaced with Yamaha outboard engine(s) compatible with Command Link
®
,
Command Link Plus
®
and Helm Master
®
, the TZT16F can display engine information
on a dedicated Yamaha engine status display.
How to connect the engine
The TZT16F connects to the Yamaha engine network via the Yamaha Interface Unit.
Arrange the Yamaha Interface Unit through a local Yamaha representative.
The Yamaha Engine Hub (Yamaha supply), which connects between the engine and
the Yamaha Interface Unit, is also required.
Ethernet cable Ethernet cable CAN bus cable CAN bus cable
to CAN bus sensors to CAN bus sensors
TZT12/16/19F
TZT12/16/19F
Yamaha Interface Unit
To NMEA 2000 Backbone
(Micro-C cable(Male))
To Yamaha Engine Hub
(Command Link cable)
Yamaha Engine Hub