Furuno TZT16F, Installation Manual

Page: 25 / 67

1. MOUNTING
1-17
3. If a hole has been drilled in the transom, open the appropriate slot in the transom
cable cover. Position the cover over the cable where it enters the hull. Mark the
two mounting holes.
4. At each of the marked locations, use a 3 mm or 1/8” bit to drill a hole 10 mm
(3/8”) deep. The prevent drilling too deeply, wrap masking tape around the bit 10
mm (3/8”) from the point.
5. Apply marine sealant to the threads of the #6 x 1/2” self-tapping screw to prevent
water from seeping into the transom. If you have drilled a hole through the
transom, apply marine sealant to the space around the cable where it passes
through the transom.
6. Position the two cable clamps and fasten them in place. If used, push the cable
cover over the cable and screw it in place.
7. Route the cable to the display unit being careful not to tear the cable jacket when
passing it though the bulkhead(s) and other parts of the boat. To reduce electrical
interference, separate the sensor cable from other electrical wiring and "noise"
sources. Coil any excess cable and secure it in place with zip-ties to prevent
damage.