Furuno TZT16F, Installation Manual

Page: 12 / 67

1. MOUNTING
1-4
1.1.2 Retrofit Kit for TZT16F (option)
When upgrading to the TZT16F, use the retrofit kit (OP19-23).
Type: OP19-23 Code No. 001-563-980
1. Prepare a cutout in the mounting location using the template (supplied) for the
TZT16F.
2. Place the TZT16F unit face-down on a a soft, clean surface.
3. Set the F Mount Panel to the TZT16F unit, then using the hex bolts attached to
TZT16F, fix the F Mount Panel to the unit.
4. Connect necessary cable, referring to chapter 2.
5. Set the unit and F Mount Panel into the cutout as shown in the figure to the right,
then use the supplied self-tapping screws (SUS304

6 pcs.), fix the F Mount
Panel to the console.
Note: Be careful not to pinch the cables connected at step 4.
Note: Where the mounting location may be exposed to water (spray or splash),
apply a bead of marine sealant around the rear of the F Mount Panel, for water-
Optional kit Type Code No. Qty
F Mount Panel 16 19-034-1481 100-431-270-10 1
Self-tapping screws 5X20 SUS304 001-336-820-10 6
Hex bolt
TZT unit TZT unit
Hex bolt
Frontmount panel