Furuno NAVpilot-500, Installation Manual

Page: 52 / 67

3. ADJUSTMENTS
3-22
3.6.3 Clearing all data
All memories can be cleared to restore default settings.
1. Open the DOCKSIDE SETUP menu.
2. Rotate the course control knob to select COMPASS TYPE, and then press the course
control knob.
3. Rotate the course control knob to select “OTHER”, and then press the course control
knob.
4. Press the [MENU] key twice to close the INSTALLATION menu.
5. Press the [MENU] key to show the main menu.
6. Rotate the course control knob to select SYSTEM SETUP, and then press the course
control knob.
KEY BEEP:
LOCK:
UNLOCK
LANGUAGE: ENGLISH
PANNEL DIMMER: 1
REMOTE CONTROLLER 1: NFU
REMOTE CONTROLLER 2: NFU
CSE AFTER REMOTE:
PRESENT COURSE
NEXT PAGE
OFF
PREVIOUS PAGE
PORT 1 FORMAT:
NMEA0183 V1.5
DATA OUT
PORT 2 FORMAT:
NMEA0183 V1.5
DATA OUT
SIMULATION MODE: OFF
MEMORY CLEAR: NO
Page 1
Page 2
PUSH MENU KEY O RETURN
TO PREVIOUS MENU.
PUSH MENU KEY O RETURN
TO PREVIOUS MENU.
System setup menu (through the main menu)
7. Rotate the course control knob to select MEMORY CLEAR at the bottom of the second
page, and then press the course control knob to show the option window.
DISPLAY CLEAR
ALL CLEAR
Memory clear option window
8. Rotate the course control knob to select “ALL CLEAR”, and then press the course
control knob.
You are asked if you are sure to clear memory.
9. Press the course control knob to clear, or press any key to escape.
When the course control knob is pressed, the equipment restarts automatically.