Furuno NAVpilot-500, Installation Manual

Page: 37 / 67

3. ADJUSTMENTS
3-7
RUDDER SETUP AND AUTO TEST
DRIVE TYPE: _
BYPASS/CLUTCH: _
RUDDER DB : _. _
RUDDER SPEED: _ _. _ /s
RUDDER DUTY: _ _ %
Rudder setup and auto test menu
When the rudder test is finished, a beep sounds and the message “RUDDER TEST
COMPLETED.” appears.
The results are shown on the menu.
DRIVE TYPE: REVERSIBLE or SOLENOID
BYPASS/CLUTCH: EXIST or NON
RUDDER DB: Shows the rudder deadband.
RUDDER SPEED: Rudder speed
RUDDER DUTY: PWM duty for control of pump output
7. Press any key to close the RUDDER TEST menu.
3.2.11 Setting course changing speed
Set the course changing speed (the speed in degree per second) when turning the boat in
the AUTO or NAV mode.
1. Rotate the course control knob to select “RATE OF TURN” on the DOCKSIDE SETUP
menu.
2. Press the course control knob and the current value is circumscribed with a double
rectangle.
3. Rotate the course control knob to set the degree which you wish turn the ship in a
second. (Setting range: 1 to 9°)
4. Press the course control knob to finish.
3.2.12 Selecting compass type
Select the heading sensor connected to your NAVpilot-500/511.
1. Rotate the course control knob to select “COMPASS TYPE.”
2. Press the course control knob to show the compass type options window.
PG-1000
OTHER
PG-500
Compass type options window