Furuno GP-150-Dual, Operator'S Manual, Page: 85 / 130

10. INSTALLATION
10-13
DATA1 output setting
1) Press MENU ESC , 9 and 3 keys to show the DATA1, 3 OUTPUT SETUP
menu.
Talker ID GP LC DE
Output Data (00-90 sec) 82%
1. AAM:00 APA:00 APB:04 BOD:00
2. BWC:00 BWW:00 GGA:01 GLL:01
3. RMB:01 RMC:00 VTG:01 WCV:00
4. VDR:00 WPL:00 XTE:00 ZDA:01
5. GNS:00 GBS:01 Rnn:00 RTE:00
DATA3. Log Pulse 400ppm
DATA 1, 3 OUTPUT SETUP
MENU : Escape
ENT : Enter
200ppm
Settings shown above are default settings.
This line appears only when LOG is
selected by internal jumper blocks.
Data FMT V1.5 IEC
TX rate of operation
V2.0
DATA1, 3 OUTPUT SETUP menu
2) Press to select DATA FMT.
3) Press or to select V1.5, V2.0 or IEC.
4) Press the
CU/NU ENT key. Talker ID appears in reverse video.
5) Press or to select GP, LC or DE.
6) Press the
CU/NU ENT key.
7) Enter TX interval for each output data sentence in line 1. TX interval is
available in 00, 01, 02, 03, 04, 05, 06, 10. 15, 20. 30, 60 and 90 sec.
8) Press the MENU ENT key.
9) Enter TX interval for each output data sentence in lines 2 through 5. Press
the CU/NUENT key after setting each line.
In great circle calculation, BWC and WNC are output but BWR and WNR are not.
In rhumb line navigation, BWR and WNR are output but BWC and WNC are not.
The total data output are shown by percentage on the third line.
For best results the total output should be less than 90%; lengthen the Tx
interval of less important data to make the total output less than 90%.