Furuno FSV-75, Installation Manual

Page: 49 / 135

1. MOUNTING
1-41
4. Insert two of the bolts removed at step 3 in the locations indicated in the figure be-
low, to raise the tank guide. Raise the tank guide until it can be rotated.
5. Rotate the tank guide until the rollers on the tank guide do not come into contact
with the weld bead on the retraction tank.
6. Remove the two bolts inserted at step 4
7. Reinsert the four bolts removed at step 3 and attach stainless wires* as shown be-
low.
*: Use the stainless steel wire included in the attachment flange or attachment kit.
8. Remove the four bolts inserted at step 2.
9. Raise the transducer.
1
2
3
4
Stainless wire
Approx.
20 mm
1) Insert the stainless wire to the hole on
the side of the hex socket head bolt.
Hex socket head bolt
2) Twist the wire in the clockwise
direction.
3) Insert the wire to the next bolt, then twist
the wire in the counterclockwise direction.
4) Cut the wire, leaving approx. 20 mm loose.
Wrap the loose wire around the last bolt.
Attach the stainless wire
between bolts
1
and
2
,
3
and
4
. Start at bolts
1
and
3
.