Furuno FCV-1900, Installation Manual

Page: 33 / 64

3. INITIAL SETTINGS
25
Dual frequency transducers
Manual setting
For transducer not listed in the table above, set [HF XDCR Select] to [Manual], then
set the TX power, frequency and bandwidth.
1. Display the [XDCR setting menu], referring to the previous procedure.
2. Set [HF XDCR Select] to [Manual].
Confirm that the high freq. transducer is connected to the HF port.
3. Set [HF connection] to [Connected].
4. Set [Voltage] according to the transducer voltage.
Note: The selectable maximum voltage is changed depending on the frequency
setting.
5. Set a frequency from the [Freq.] menu.
The band width is automatically set, however it can be entered manually with
[Band width].
6. Set the LF transducer in a similar manner.
Single frequency setting
When only one transducer is used, connect the transducer to either the high or low
transducer port, then set the connected port [connection] to [Connected].
Output
power (kW)
Frequency (kHz) Model Remarks
1 42-65/130-210 CM265LH
ACCU-FISH
™
compatible
42-65/85-135 CM265LM
42-65/150-250 CM275LH-W Wide beam type
2 38-75/130-210 PM111LH
ACCU-FISH
™
compatible
38-75/80-130 PM111LM
3 28-60/130/210 CM599LH
ACCU-FISH
™
compatible
28-60/80-130 CM599LM