Furuno FCV-1900, Installation Manual

Page: 30 / 64

3. INITIAL SETTINGS
22
5. Rotate the ENTER knob to select the resolution of
your monitor, then push the knob.
The confirmation massage shown to the right appears.
6. Push the ENTER knob to restart the system.
The message shown below appears, then the system
reconstruction starts.
The update process can take several minutes, during which the screen remains
blank. When the procedure is completed, the startup display appears, then the
normal display appears.
Note: Long-press the RANGE key for 10 seconds to set the resolution to XGA
(1024
×
768).
3.3 Transducer Setting
The menu tabs names listed below are for setting up external transducers. This allows
you to adjust the transducer settings from the FCV-1900.
• DFF1/DFF3/BBDS1 transducer
• Telesounder (products sold only in Japan)
Select the transducer
1. Referring to section 3.2, open the [Service] menu.
2. After you have selected [Service], the following message appears.
3. Select [Yes] and push the ENTER knob to turn the power off.
Yes
Display resolution was
changed.
The controls will be
inoperable and the
screen will go dark for
five to ten minutes.
Remove the USB device,
then restart the system.
WARNING: SYSTEM RECONSTRUCTING
• Keep USB memory disconnected.
• Do not disconnect the control unit.
• The screen goes blank after this page disappears. Do not turn the power off.
The screen turns on again after reconstructing is completed.
CAUTION
Set the transducer data properly.
Wrong data setting may damage the
transducer and void the warranty.
Yes
No
System will power down
automatically. Turn the
power on again, and
change the tarnsducer
setting.