Furuno FCV-1900, Installation Manual, Page: 34 / 64

3. INITIAL SETTINGS
26
3.4 NMEA Port Setting
The [NMEA Port Set&Monitor] menu sets up the NMEA port and shows the data input/
output from the NMEA ports.
Rotate the ENTER knob to select the port that you want to set up and push the knob
to open the [Setting] window.
[NMEA0183] : Select NMEA0183 version of navigation equipment connected to the
NMEA port (SC and CIF are not available). The choices are [Ver1.5], [Ver2.0], [Ver3.0]
and [Special]. [Special] is for use with a navigator whose baud rate is 600bps.
[Output Data] : Select the data to output from the NMEA port to navigation equipment
(SC and CIF are not available).
[TLL Output] : Select the TLL data type to output from the NMEA port to a chart plotter
(SC and CIF are not available).
[NMEA Port Setting] : Select the format for the communication port’s data. The set-
tings are as follows.
• Baud Rate: 600/4800/38400 bps for NMEA and 600/1200/2400/4800 bps for CIF
• Start Bit: 1 bit (fixed)
• Data Length: 8 bit (fixed)
• Stop Bit: 1 bit (fixed)
• Parity: none (fixed)
[Clear Window] : Refresh the information shown on the communication port monitor
display.
[Exit] : Close the [NMEA Port Set&Monitor] menu to return to the main menu.
NMEA1
NMEA2
SC
CIF
Set up the CN-10 (NMEA1) port
Set up the CN-11 (NMEA2) port
Set up the CN-12 (NMEA3) port
Set up the CN-6 (SONDE/TRIG) port
NMEA Port 1 Input NMEA Port 1 Output
㪲㪤㪜㪥㪬㪆㪜㪪㪚㪴㩷㪑㩷㪪㪼㫋㫋㫀㫅㪾
㪪㪼㫃㪼㪺㫋㩷㪜㫏㫀㫋㩷㫄㪼㫅㫌㩷㫋㫆㩷㪼㫏㫀㫋
$GPGNS,102716.01,8900.0413,N,17859.99
99,E,A,00,0.0,0.0,0.0,0.0,0.0,S*4F
$GPMTW,27.30,C*32
$GPVHW,0.00,T359.94,M,8.10,N,,*1C
$GPVTG,359.95,T,359.95,M,6,6.48,N,,,A*7C
$GPZDA,102716.20,24,02,2015,00,00*65 $SDDBT,102.6,f,31.3,M,17.1,F*05
$SDDPT,31.3,0.0,200.0*66
SSDDBT,T102.6,f,31.3,M,17.1,F*05
$SDDPT,31.3,0.0,200.0*66
Setting
NMEA 0183
Output Data
TLL Output
NMEA Port Setting
Baud Rate
Start Bit
Data Length
Stop Bit
Parity
Clear Window
Exit
Ver1.5
TLL
600
1bit
8bit
1bit
none
Port selection
[Setting] window
Communication port
monitor display
(see section 3.5)