Furuno CSH-5L, Installation Manual

Page: 31 / 100

2. WIRING
2-3
2.2 Hull unit/Pre-amplifier Unit
2.2.1 Running transducer cable
Excessive stress should not be placed on the transducer cables (12 pcs.) during raise/lower
operation. Follow the procedure below to run the cables.
1. Fix the 12 transducer cables with the cable clamp [A].
Cable clamp [A]
Cable clamp [B]
Raise/lower
drive assembly
Cable clamp (1)
2. Temporarily fix cable clamp [B]. Note the positions of cable in clamps [A] and [B] as
shown below.
Cable
clamp [A]
Cable clamp [B]
Ex) The cable which is fixed at
(a) of the clamp [A] should be
wired to (a) of the clamp [B].
Cable clamp (2)