Furuno CSH-5L, Installation Manual

Page: 3 / 100

i
SAFETY INSTRUCTIONS
WARNING
Do not install the equipment where it
may get wet from rain or water splash.
Water in the equipment can result in fire,
electrical shock or equipment damage.
Be sure no water leaks in at the trans-
ducer installation site.
Water leakage can sink the vessel. Also
confirm that the transducer will not loosen
by ship's vibration. The installer of the
equipment is solely responsible for the
proper installation of the equipment.
FURUNO will assume no responsibility for
any damage associated with improper
installation.
ELECTRICAL SHOCK HAZARD
Do not open the equipment
unless totally familiar with
electrical circuits and service
manual.
Only qualified personnel should
work inside the equipment.
WARNING
Install the specified transducer tank
in accordance with the installation
instructions. If a different tank is to be
installed the shipyard is solely respon-
sible for its installation, and it should
be installed so the hull will not be
damaged if the tank strikes an object.
The tank or hull may be damaged if the
tank strikes an object.
When assembling the hull unit, fasten
the shaft retainer and fastening band
with the torques shown below.
Shaft retainer: 20 to 25 N m
Fastening band: 6 to 8 N m
If torques are less than the above,
water leakage may occur because the
shaft may loosen and fall.
Turn off the power at the
switchboard before beginning
the installation.
Fire or electrical shock can result
if the power is left on.