English
13
Troubleshooting
Before contacting the Furrion Customer Service:
1. Try to solve the problem yourself following the points described in the table below.
2. Turn off the appliance and restart it to see if the fault persists.
Trouble
Possible Cause
Cooler does not work
The Cooler is not powered on. Refer Power On/Off section in Page 9 for
instructions).
The circuit breaker tripped or fuse blown.
Compressor turns on and off frequently
The lid is open or is frequently opened, or gasket is torn, ripped or
removed.
The temperature is not set correctly.
Cooling compartments are too warm
Temperature control is not set correctly ( see page 9 for setting
compartment temperature).
The lid gasket does not seal properly.
The lid is open or is frequently opened.
The cooler has recently been disconnected for a period of time.
Vibrating or rattling (slight vibration is
normal)
The cooler is placed on uneven or weak surface.
Moisture collects inside the cooler
The lid is open or is frequently opened.
Moisture forms on the outside of the
cooler
This is normal in hot and humid weather.
Bubbling or gurgling sounds (like boiling
water)
This is the normal sound of refrigerant (used to cool cooler) circulating
throughout the system.
Popping or cracking sounds when
compressor comes on
This is normal for metal parts to undergo expansion and contraction, like
hot water pipes.
The lid can't be closed properly.
The gasket is dirty or bent.
The basket is not seated properly.
Storage compartment is too full and items are interfering with the lid.
Lid latch is damaged or obstructed by sand, screes or something else.
Error Code
Codes
Possible Causes
E0
Battery is not recognized by the appliance.
Lo
Compressor low voltage protection.
E2
Fan over-current cut-out.
Hot
Thermal cut-out of electronic unit.
E6
Controller hardware of the compressor failure (controller detects abnormal parameters)
E7
Cold storage NTC short circuit
E8
Cold storage NTC open
- -
Gyroscope malfunction does not work or ePod
TM
Battery is not discovered.
