20
Ini
tial Setups
EN
Manual Tuning
Manually tune each channel.
1
In stop mode, press [SETUP]. Select
“General Setting” using [
U
/
D
],
then press [ENTER].
2
Select “Channel” using [
U
/
D
], then
press [ENTER].
3
Select “Manual Tuning” using
[
U
/
D
], then press [ENTER].
4
Select “Position” using [
U
/
D
], then
press [
P
].
“P01” is highlighted.
5
Select the position number you wish
to use using [the Number buttons] or
[
U
/
D
], then press [
L
].
You can select position numbers 01 to 99.
6
Select “Channel” using [
U
/
D
], then
press [
P
].
7
Press [
U
/
D
] to start scanning.
• The tuner will begin to search up or down
automatically. When a channel is found, the unit
will stop searching and the picture will appear
on the TV screen.
• You can select a desired channel number using
[the Number buttons]
. Refer to the following
Channel Plan table and press the three digits to
select the channel number.
(To select channel 4, press
[0]
first and then
press
[0]
and
[4]
. Or press
[4]
and then “– – 4”
appears and wait for 2 seconds.)
• If this is the channel you want, press
[
L
]
.
This unit can receive the Hyper and Oscar
frequency bands.
• If “Skip” is set to “ON”, select “Skip” using
[
U
/
D
]
, then press
[
P
]
. Select “OFF” using
[
U
/
D
]
, then press
[
L
]
.
• If you want to decode scrambled signals, select
“Decoder” using
[
U
/
D
]
, then press
[
P
]
. Select
“ON” using
[
U
/
D
]
, then press
[
L
]
.
• To store another channel, repeat steps 4 to 7.
8
After completion, press [SETUP] to
exit.
To Select a Channel
You can select a channel using
[PROG.
U
/
D
]
, or
directly enter the channel using
[the Number
buttons]
on the remote control.
Notes on using [the Number buttons]:
• Enter channel numbers as a two-digit number for
the quickest result. For example, to select channel
6, press
[0]
and
[6]
. If you only press
[6]
, channel 6
will be selected after 2 seconds. You can only select
channels 1 to 99.
• You can select the external input mode “AV1”, “AV2”
or “AV3”.
•To select “AV1”, press
[0]
,
[0]
,
[1]
.
•To select “AV2”, press
[0]
,
[0]
,
[2]
.
•To select “AV3”, press
[0]
,
[0]
,
[3]
.
Manual Tuning
Channel
Decoder
Skip
Position
1
OFF
ON
P01
Channel Plan
CH Indication
TV Channel
02 – 12
E2 – E12
21 – 69
E21 – E69
74 – 78
X, Y, Z, Z+1, Z+2
80 – 99,100
S1 – S20,GAP
121 – 141
S21 – S41
142 – 153
R1 – R12
E9G04ED_EN.book Page 20 Tuesday, March 27, 2007 10:27 AM
