13
FEATURES AND CONTROLS
WARNING!
The power supply for this product must be protected by a
residual current device rated at 30mA or less.
Bevel adjustment (fig. 11)
1.
To prevent diamond cutting disc (7)
damage ensure the motor head (20) is in
the upright position
2.
Loosen the head clamping handle (4).
3.
Adjust the motor head (20) to the desired
angle anywhere between 0º & 45º.
4.
Tighten the head clamping handle securely.
Fig. 11
Depth adjustment (fig. 12)
1. Depth Lock:
Use the depth lock to lock
the motor head (20) in the down position;
turn it clockwise while the motor head (20)
is down to lock, and turn it anti-clockwise
while holding down the motor head (20) to
raise.
2. Depth Stop:
This controls the maximum
cut depth. If the blade cuts too deeply
or too shallowly; loosen the depth stop,
adjust the depth stop lock, and tighten the
depth stop again.
Depth Stop Lock
Depth Stop
Depth Lock
Fig. 12
WARNING!
When plunge cutting ensure diamond cutting disc (7) does
not contact work table (1).
