Preparation for use and operation
Setting up the PC
10
A26361-K520-Z100-4-7619
Setting up the PC
!
When installing your PC, give consideration to the recommendations and safety notes in
the manual "Safety, Guarantee and Ergonomics".
Set up the PC only in its correct orientation. The points to observe are illustrated on the
following pages.
We recommend that you place your equipment on a surface with good anti-slip qualities.
In view of the multitude of different finishes and varnishes used on furniture, it is possible
that the rubber feet of the devices will mark the surface they stand on.
Do not expose the PC to extreme environmental conditions (see chapter "
data
"). Protect it from dust, humidity and heat.
Provide at least 200 mm of clearance on the left, in front of and behind the ventilator area
of the system unit to ensure adequate ventilation. Do not cover the ventilation areas of the
monitor and the system unit.
Do not place any objects that weigh more than 40 kg on the system unit and not several
system units one above the other.
Connecting devices
!
The power plug must be disconnected!
Read the documentation on the external device before connecting it.
Do not connect or disconnect cables during a thunderstorm.
Always take hold of the actual plug body. Never unplug a cable by pulling the cable itself.
Connect and disconnect the cables in the order described below.
Connecting cables
•
Turn off all power and equipment switches.
•
Unplug all power plugs from the grounded power outlets.
•
Connect all cables at the system unit and peripherals. You must observe the information
provided in the chapter "Important notes".
•
Plug all data communication cables into the utility sockets.
•
Plug all power cables into the grounded power outlets.
Disconnecting cables
•
Turn off all power and equipment switches.
•
Unplug all power plugs from the grounded power outlets.
•
Unplug all data communication cables from the utility sockets.
•
Disconnect all cables from the system unit and peripherals.
