62
Options Guide
TX300
S3
Installing the SAS/SATA HDD extension box
Accessible drives
Figure 51: Attaching the EasyClick rails - multibay
Ê
Screw the EasyClick rails onto either side of the multibay using two
M3x4.5mm screws (1).
Use the first hole in each lower row of holes as shown in the figure.
Ê
Push the multibay fully into the bay until the EasyClick rails latch in place.
Ê
Install a slimline floppy disk drive, a slimline DVD drive and/or a LocalView
module (see the descriptions before).
Ê
Close the server, connect it to the power outlet, and switch it on as described
in the
chapter “Completion” on page 79
ff.
8.6
Installing the SAS/SATA HDD extension box
In the second and the third 5.25-inch bay a SAS/SATA HDD extension box can
be installed. This SAS/SATA HDD extension box can be equipped with a slimline
floppy disk drive (or a LocalView module), a slimline CD/DVD drive and two
SAS/SATA hard disks.
Ê
Open the server and remove the front cover or rack front cover as described
in the in the
chapter “Preparation” on page 17
ff.
Ê
If a drive has been installed in the second or the third 5.25-inch bay, remove
the drive and install it in the first 5.25-inch bay (if the bay is free, see
section
“Installing an accessible 5.25-inch drive” on page 47
).
1
1