TX100 S2 Core Edition
Operating Manual
53
Installation and operation
V
–
It is highly recommended to take note of the original network
setting values (e.g. IP address, subnet mask, default gateway)
before altering the network configuration.
–
Please take extreme care when changing network
configuration settings!
Incorrect network settings may render the Headless server
inaccessible! It will be impossible to connect to the server or to
correct the error remotely!
If the Remote Desktop connection should fail, even after
integrating the server into its destination network, please refer to
section "Operating system recovery" on page 69
To specify IPv4 IP address settings, do one of the following:
Ê
To get IP settings automatically using DHCP, click
Obtain an IP address
automatically
, and then click
OK
.
Ê
To specify an IP address, click
Use the following IP address
, and then, in
the
IP address
,
Subnet mask
, and
Default gateway
boxes, type the IP
address settings.
To specify IPv6 IP address settings, do one of the following:
Ê
To get IP settings automatically using DHCP, click
Obtain an IPv6 address
automatically
, and then click
OK
.
Ê
To specify an IP address, click
Use the following IPv6 address
, and then, in
the
IPv6 address
,
Subnet prefix length
, and
Default gateway
boxes, type the
IP address settings.
To specify DNS server address settings, do one of the following:
Ê
To get a DNS server address automatically using DHCP, click
Obtain DNS
server address automatically
, and then click
OK
.
Ê
To specify a DNS server address, click
Use the following DNS server
addresses
, and then, in the
Preferred DNS server
and
Alternate DNS server
boxes, type the addresses of the primary and secondary DNS servers.
Ê
To change advanced DNS, WINS, and IP settings, click
Advanced
.
