Fujitsu PRIMERGY RX2520 M4, Upgrade And Maintenance Manual, Page: 84 / 456

84 Upgrade and Maintenance Manual
RX2520 M4
Basic software procedures
5.2.8 Enabling the boot watchdog (iRMC S5)
If the boot watchdog has been disabled for firmware upgrade purposes (see
section
"Disabling the boot watchdog (iRMC S5)" on page 68 ), it has to be re-
enabled to complete the maintenance task.
Timer settings can be configured in the BIOS or using the ServerView iRMC
web interface.
Enabling the boot watchdog in the BIOS
Ê
Enter the BIOS.
Ê
Select the Server Mgmt menu.
Ê
Under Boot Watchdog set the Action setting to Reset .
Ê
Save your changes and exit the BIOS.
I
For more information on how to access the BIOS and modify settings,
see the corresponding BIOS Setup Utility reference manual.
Enabling the boot watchdog using the iRMC web interface
Ê
Log in to the ServerView iRMC web interface.
Ê
Select the Settings menu.
Ê
Open the Server Management page.
Ê
In the Boot Watchdog group, check the Enable Boot Watchdog option.
The
Enable Boot Watchdog
option must be selected.
Ê
Select Reset from the Watchdog Action list.
Ê
Click Apply for the changes to take effect.
I
For more information on iRMC settings, see the iRMC user guides.
5.2.9 Enabling replaced components in the BIOS
When a CPU, an expansion card, or a memory module fails, the defective
component will be set to
Disabled or Failed in the BIOS. The server will then
reboot with only the intact hardware components remaining in the system
configuration. After replacing the defective component, it needs to be re-
enabled in the BIOS.