Fujitsu PRIMERGY 300, Operating Manual

Page: 47 / 94

A26361-K423-Z202-3-7619
39
Troubleshooting and tips
!
Take note of the safety hints in the manual "Safety and Ergonomics" and
in the chapter "
Preparation for use and operation ", when you connect or
disconnect cables.
If a fault occurs, try to correct it as described:
•
in this chapter
•
in the documentation of the connected devices
•
in the help systems of the software used.
If you fail to correct the problem, proceed as follows:
Ê Switch the server off.
Ê
Make a note of the steps and the circumstances that led to the fault. Also
make a note of any error messages displayed.
Ê
Contact your sales office or customer service.
Power-on display remains dark after you have
switched on your server
This may have the following reasons:
There is a defect in the ac power supply
Ê Check whether the power cable is plugged properly into the server and power
outlet.
Ê Switch your server on.
Internal power supply overloaded
Ê
Remove the server power plug from the power outlet and wait until the power
indicator goes off.
Ê
Plug the power plug into the power outlet again.
Ê Switch your server on.