Fujitsu MPG3xxxAT, Product Manual

Page: 108 / 201

C141-E110-02EN 5 - 41
If device 1 is present:
•
Both devices shall execute self-diagnosis.
•
The device 0 waits for up to 5 seconds until device 1 asserts the PDIAG- signal.
•
If the device 1 does not assert the PDIAG- signal but indicates an error, the device 0 shall
append X'80' to its own diagnostic status.
•
The device 0 clears the BSY bit of the Status register and generates an interrupt. (The device
1 does not generate an interrupt.)
•
A diagnostic status of the device 0 is read by the host system. When a diagnostic failure of
the device 1 is detected, the host system can read a status of the device 1 by setting the DV bit
(selecting the device 1).
When device 1 is not present:
•
The device 0 posts only the results of its own self-diagnosis.
•
The device 0 clears the BSY bit of the Status register, and generates an interrupt.
Table 5.7 lists the diagnostic code written in the Error register which is 8-bit code.
If the device 1 fails the self-diagnosis, the device 0 "ORs" X'80' with its own status and sets that
code to the Error register.
Table 5.7 Diagnostic code
Code Result of diagnostic
X‘00’
X‘01’
X‘02’
X‘03’
X‘04’
X‘05’
X‘06’
X‘8x’ Mechanical failure
No error detected
Hardware error
Buffer failure
SRAM failure
SA read failure
Power ON calibration failure
Failure of device 1
At command issuance (I/O registers setting contents)
1F7
H
(CM) 1 0 0 1 0 0 0 0
1F6
H
(DH)
× × ×
DV xx
1F5
H
(CH)
1F4
H
(CL)
1F3
H
(SN)
1F2
H
(SC)
1F1
H
(FR)
xx
xx
xx
xx
xx