Fujitsu MAN3367FC - Enterprise 36.7 GB Hard Drive, Product/Maintenance Manual

Page: 12 / 148

Important Alert Items
vi C141-E133-02EN
Task Alert message Page
Mounting Installation
•
Then, dismount the drive using the drive
mounting/dismounting mechanism, etc. of the system. If
the drive is dismounted while the spindle motor is running,
special care is required to avoid excessive vibration or
shock to the drive. It is recommended to stop the operation
once the SCA connector breaks off contact and wait until
the spindle motor stops (about 30 seconds) before dismount
the drive.
•
When storing or transporting the drive, put it in an
antistatic bag. (Shown in Section 5.1).
2. When dismounting the drive which is mounted on the system
while power is not supplied to it.
•
Do not move the drive until the drive stops completely
(about 30 seconds if the spindle motor was stopped by a
START/STOP UNIT command, and about 30 seconds after
powering-off when the power was simply turned off).
•
Then, dismount the drive using the drive
mounting/dismounting mechanism, etc. of the system.
•
When storing or transporting the drive, put it in an
antistatic bag. (Shown in Section 5.1).
5-5
Data loss
When the SEND DIAGNOSTIC command terminates with the
CHECK CONDITION status, the INIT must collect the error
information using the REQUEST SENSE command. The RECEIVE
DIAGNOSTIC RESULTS command cannot read out the error
information detected in the self-diagnostics.
6-4
Caution
1. To avoid injury, do not touch the mechanical assembly during
disk drive operation.
2. Do not use solvents to clean the disk drive.
6-5
Caution
1. Always ground yourself with a wrist strap connected to ground
before handling. ESD (Electrostatics Discharge) may cause
the damage to the device.
2. Do not remove a PCA. This operation is required to prevent
unexpected or unpredictable operation.
3. Do not use a conductive cleaner to clean a disk drive assembly.
6-6
Damage
Never open the disk enclosure in the field. Opening the disk
enclosure in the field may cause an irreparable fault.
6-6
Data loss
Save data stored on the disk drive before requesting repair. Fujitsu
does not assume responsibility if data is destroyed during servicing
or repair.
6-7