Fujitsu Lifebook C2210 User Manual Download Page 50

Page: 50 / 116

L i f e B o o k C S e r i e s N o t e b o o k – S e c t i o n F o u r

Figure 4-7 Installing/Removing PC Cards

PC Cards

Your LifeBook notebook supports Type I, Type II and
Type III PC Cards, which can perform a variety of func-
tions depending on which type of card you install. You
can install one or two PC Cards at a time, depending on
its type. Type I/II PC Cards can be installed together,
while Type III PC Cards must be installed alone.

Some available PC Cards:

■

Fax/data modem cards (Type II)

■

Local area network (LAN) cards (Type II)

■

IDE solid-state disk cards (Type II)

■

SCSI cards (Type II)

■

Wireless LAN (802.11b) cards (Type II)

■

Hard Drive (ATA) cards (Type III)

■

Other PC Cards that conform to PCMCIA 2.1 or
CardBus standards

For further information, refer to the instructions
supplied with your PC Card.

INSTALLING PC CARDS

PC Cards are installed in the PC Card slot. To install a

PC Card(s), follow these easy steps:

1. See your PC Card manual for instructions on the

installation of your card. Some cards may require
that your notebook is off while installing them.

2. Make sure there is no PC Card currently in the slot.

If there is, see Removing PC Cards.

3. If either of the eject buttons is extended, press it in

until it clicks.

4. Insert your PC Card into the slot with the product

label facing up.

5. Push the card firmly into the slot until it is seated in

the connector.

REMOVING PC CARDS

To remove a PC Card(s), follow these easy steps:

1. See your PC Card manual for specific instructions

on removing your card. Some PC Cards may require
your LifeBook notebook to be in Suspend Mode or
Off while removing them.

2. Unlock the card from the slot by pressing the eject

button associated with the slot in which the card is
located. When pressed, the button will pop out.

3. Firmly press the button again until it is flush with

the notebook. This will eject the card slightly out of
the slot allowing you to remove the card.

PC Card Slot

PC Card

Eject Button

W A R N I N G

■

Installing or removing a PC Card(s) during your Life-
Book notebook’s shutdown or bootup process may
damage the card and/or your LifeBook notebook.

■

Do not insert a PC Card into a slot if there is water or
any other substance on the card as you may perma-
nently damage the card, your LifeBook notebook, or
both.

P O I N T

You may be required to log on as an Administrator or a
member of the Administrator’s Group to complete this
procedure. If your computer is connected to a network,
network policy settings may also prevent you from
completing this procedure.

P O I N T

■

Windows has a shutdown procedure for PC Cards
that must be followed before removing a card.
(Review your operating system manual for the correct
procedure.) It is good practice to remove devices
using the Unplug or Eject Hardware icon in the
system tray.

■

If the dialog box states that the device cannot be
removed, you must save all of your open files, close
any open applications and shut down your notebook.
Once your LifeBook notebook has been shut down,
you must turn Off the power using the power switch.

C A U T I O N

If the PC Card(s) has an external connector and cable,
do not pull the cable when removing the card.

Brie-C2210.book Page 44 Friday, September 13, 2002 4:43 PM