Chapter 8 Operational Settings
155
Document check area
specification for Multifeed
Detection
Selected range: Select this item to restrict the
area to run multifeed detection.
[Selected range] check box
Not selected
Enable/Disable (Middle): Specify whether to
enable or disable multifeed detection in the
selected area.
Enable/Disable
(When [Selected range] is selected)
Disable
Start (Middle): Specify the start position of the
area in length (mm) from the leading edge of
the document.
0 to 510 mm (in increments of 2)
0 mm
End (Middle): Specify the end position of the
area in length (mm) from the leading edge of
the document.
0 to 510 mm (in increments of 2)
0 mm
Intelligent Multifeed Function
When there is a paper of the same size
attached to a designated location on the page,
you can configure the scanner to memorize the
location of the attachment and not detect
multifeeds for that location.
Note that you first need to select [Check
Overlapping (Ultrasonic)] or [Check
Overlapping and Length] in either the scanner
driver or the multifeed detection setting in
"Specifying a Multifeed Detection Method
[Multifeed]" (page 176)
This setting can also be configured with the
operator panel.
Manual mode/Auto mode 1/Auto mode 2
Manual mode
Select to clear the overlap pattern (length,
location) memorized in Auto mode.
This setting can also be configured with the
operator panel.
[Clear overlap pattern] check box
Not selected
Select to memorize the multifeed pattern on the
window to check an image that is detected as
multifeed.
[Auto-Memorize MF Pattern (only when MF
images are displayed)] check box
Not selected
Specify whether or not to memorize the
multifeed pattern upon power-off.
Remember/Do not remember
Do not remember
Item
Description
Parameter/Value
Factory Default
