8.1.2.2
iSCSI Port Parameter Settings
Set the connection information between the host interface port and the server.
The procedure to set the port parameters is as follows.
The setting screen that is displayed depends on the host interface port that is being used.
Set the connection information for the iSCSI ports on the ETERNUS DX Disk storage system and the server.
1
Click the [Connectivity] tab on the navigation of the ETERNUS Web GUI screen. On the [Connectivity]
screen, click [iSCSI] under [Port Group] in [Category].
The [iSCSI Port Group] screen appears.
2
Select the checkbox for the iSCSI port to set the port parameters for in the [iSCSI Port Group] screen and
then click [Modify iSCSI Port Parameters] in [Action].
The [Modify iSCSI Port Parameters] screen appears.
3
Select the target port, specify the items (for TCP/IP settings, iSCSI settings, basic settings, and security
settings), and then click the [Set] button.
•
iSCSI Name can be managed more easily if the port name is added to the end of the default.
•
When multiple target ports are selected, the parameters must be set for multiple ports.
Select the port to be set from the pull-down menu.
The following items are set as shown in this example.
•
Port
CM#0 CA#0 Port#0
•
IP Version
Select an IP address type. IPv4 is used in this example.
•
IP Address
Specify an available IP address for the iSCSI network that is to be connected.
For IPv4, the subnet mask needs to be specified.
•
iSCSI Name
For multipath connections, each name must be different.
•
CHAP
Specify [ON] to use unidirectional CHAP authentication or bidirectional CHAP authentication for the
target port and [OFF] to use neither of them.
Chapter 8 SAN Connection Settings
8.1 Connection Settings for the ETERNUS DX Disk Storage System
128
FUJITSU Storage ETERNUS DX100 S3/DX200 S3 Disk storage system Configuration Guide (Basic)
Copyright 2014 FUJITSU LIMITED
P3AM-7652-02ENZ0
Summary of Contents for ETERNUS DX100 S3
Page 2: ...This page is intentionally left blank ...
Page 188: ......
