Fujitsu Esprimo P2 Series, Operating Manual, Page: 50 / 61

System expansions
Installing an accessible 5
1
/
4
inch drive (e.g. DVD drive)
► Open the casing (see "Opening the casing", Page 31 ).
Accessible drive, Drive,
► If a slide-in module is fi tted, remove this fi rst. To do this, proceed in the same way as when
removing a drive (see "Removing an accessible 5
1
/
4
inch drive (e.g. DVD drive)", Page 40 ).
Do not dispose of the empty slide-in module. For cooling, protection against
fi re, and in order to comply with EMC regulations, you must re fi t the empty
slide-in module if you remove the drive again later.
► Take the new drive out of its packaging.
► Make the desired settings on the new drive (if necessary, to the settings of
drives already installed as well (Master/Slave)).
2
1
► Slide the drive into the casing as far as it will go (1).
► Fasten the drive in place with the screws (2).
► Plug the data and the power supply connectors into the drive. Make sure the polarity is correct.
► Close the casing (see "Closing the casing", Page 32 ).
It may be necessary to modify the entry for the drive in the BIOS Setup .
42 A26361-K1007-Z220-1-7619, edition 1