Fujitsu Esprimo P2 Series, Operating Manual, Page: 36 / 61

Troubleshooting and tips
Cause Remedy
Wrong monitor has been set under Windows
Vista ► Restart the device.
► Press F8 while the system is booting.
Either the Windows Advanced Start Options menu
or the menu for selecting the operating system
appears.
► If the menu for selecting the operating
system appears, press
F8 .
► Select
Safe Mode
or
Safe Mode with Network
.
► Go to Start symbol – (Settings) – Control
Panel – Appearance and Personalization –
Personalization
and enter the correct values
for the connected monitor as described in
the operating manual of the monitor.
The wrong RAM modules have been inserted ► See the technical manual for the mainboard
for information on which memory modules
can be used.
No mouse pointer displayed on the screen
Cause Remedy
The mouse is not correctly connected. ► Shut down the operating system properly.
► Switch the device off.
► Check that the mouse cable is properly
connected to the system unit. If you use an
adapter or extension lead with the mouse
cable, check the connections.
► Make sure that only one mouse is
connected.
► Switch the device on.
The fl oppy disk cannot be read or written
Cause Remedy
The write protection of the fl oppy disk or the
fl oppy disk drive is activated.
► Check whether the write protection of
the
fl oppy disk or the fl oppy disk drive is
activated (refer to the "BIOS Setup" manual
and if necessary to the manual for the
mainboard).
The fl oppy disk drive controller is not enabled. ► Check the relevant entries for fl oppy disk
drive in the
Main
menu of the
BIOS Setup
.
► Check that the fl oppy disk drive controller
is enabled (refer also to the manual for the
mainboard or in the "BIOS Setup" manual).
The fl oppy disk drive is not connected. ► Check that the cables of the fl oppy disk
drive are properly connected.
28 A26361-K1007-Z220-1-7619, edition 1