En-12
Cleaning Ion deodorization filter and
Replacing Apple-catechin filter
1.
Remove the air filters. Refer to steps 1 ~ 2
of “Cleaning air
filter”.
2.
Remove the air cleaning filters from the air cleaning filter
holder.
Air cleaning filter
Air cleaning filter frame
3.
Flush the Ion deodorization filter (light blue) with high-
pressure hot water until the surface of the filters are covered
with water.
4.
Wash the Ion deodorization filter with diluent neutral
detergent.
Do not ream or rub, otherwise the deodorizing effect may decrease.
5.
Rinse the Ion deodorization filter with water flow.
6.
Dry the Ion deodorization filter in shade.
7.
Remove the Apple-catechin filter (light green) from the air
cleaning filter holder.
8.
Set the new or washed air cleaning filters into the air
cleaning filter frames.
NOTES:
Use the Apple-catechin filter as soon as possible after opening
the package. The air cleaning effect decreases when the filters
are left in the opened package.
9.
Install the air cleaning filter holders to the air filters.
Engage the 4 hooks at the rear of the air cleaning filter frame with
the latch at both ends of the air filter.
* Take care that the air cleaning filter does not project beyond the
frame.
Hook (4 places at the rear)
Latch (4 places)
NOTES:
Take care that the air cleaning filter does not project
beyond the frame.
10.
Replace the air filters and close the intake grille. Refer to
steps 4 ~ 5 of “Cleaning air filter”.
Replacing Ion deodorization filter
1.
Remove the air filters. Refer to steps 1 ~ 2
of “Cleaning air
filter”.
2.
Remove the Ion deodorization filter (light blue) from the air
cleaning filter holder.
3.
Install the new Ion deodorizing filter.
Removing and installing intake grille
■
Removing intake grille
1.
Open the intake grille until it snaps.
2.
Pull the mounting shafts while keeping the intake grille in a
horizontal position.
■
Installing intake grille
1.
While holding the intake grille horizontal, set the left and
right mounting shafts into the pillow blocks at the top of the
front panel.
Insert the shaft until it snaps to latch each shaft properly.
2.
Close the intake grille.
3.
Press 4 places on the intake grille to close it completely.
After extended non-use of the unit
If you have shut down the indoor unit for 1 month or more, perform the
Fan mode operation for half a day to dry the internal parts thoroughly
before the normal operation.
Additional inspection
After long period of use, accumulated dust inside the indoor unit may
reduce the performance even if you have maintained the unit properly.
In such a case, a product inspection is recommended.
For more information, consult authorized service personnel.
Filter indicator reset (Special setting)
This function can be used if set correctly during installation. Please
consult authorized service personnel in order to use this function.
)
)
Clean the air filter when the indicator lamp show the
following:
Indicator lamp
Blinking pattern
Blinks 3 times, at intervals of 21 seconds
After cleaning, reset the filter indicator by pushing
on the
indoor unit for 2 seconds or less.
9387858068-01_OM.indb 12
07-Oct-20 14:00:44
