En-6
]1]1
8. FINISHING
(1) Insulate between pipes.
●
Insulate suction and discharge pipes separately.
●
For rear, right, and bottom piping, overlap the connection pipe heat insulation and
indoor unit pipe heat insulation and bind them with vinyl tape so that there is no gap.
●
For left and left rear piping, butt the connection pipe heat insulation and indoor unit
pipe heat insulation together and bind them with and vinyl tape so that there is no gap.
●
For left and left rear piping, wrap the area which accommodates the rear piping housing
section with cloth tape.
●
For left and left rear piping, bind the connection cable to the top of the pipe with vinyl
tape.
●
For left and left rear piping, bundle the piping and drain hose together by wrapping them
with cloth tape over the range within which they
fi
t into the rear piping housing section.
(2) Temporarily fasten the connection cable along the connection pipe with vinyl tape.
(Wrap to about 1/3 the width of the tape from the bottom of the pipe so that water
does not enter.)
(3) Fasten the connection pipe to the outside wall with saddles, etc.
(4) Fill the gap between the outside wall pipe hole and the pipe with sealer so that rain
water and wind cannot blow in.
(5) Fasten the drain hose to the outside wall, etc.
*Field supplied
Pipe
Saddle*
Outside wall cap*
Sealer putty*
(Outdoors)
Wall
Overlap the insulation
Bind the pipes together so
that there is no gap.
Connection pipe
(heat insulation)
Vinyl tape
Indoor unit pipe
(heat insulation)
Wrap with cloth tape
Pipe
Drain hose
Cloth tape
Left piping
Connection
cable
Pipe
Drain hose
For connection from the left rear
Connection cable
Wall pipe
Connection pipe
Drain hose
Check the following:
GOOD
Saddle
Drain hose
Lifted up
Wave
End in water
PROHIBITED
]1
9. FRONT PANEL REMOVAL AND INSTALLATION
9.1. Intake grille removal
(1) Open the intake grille.
(2) Pull down the knob.
(3) Lift the intake grille upward, until the axle at the top of the intake grille is removed.
1
9.2. Intake grille installation
(1) The
fi
xing axle of the intake grille is installed on the Panel.
(2) Lay down the intake grille.
1
9.3. Front panel removal
(1) Remove intake grille (Reference the intake grille removal.)
(2) Remove the 6 screws.
(3) The thumb is hung on the lower part as shown in the
fi
gure, and it pulls to the front,
pushing [
▲
] mark , and bottom hooks (2 positions) is removed from wall hook bracket.
(4) The front panel is pulled to the front, raising the upper surface, and a front panel is
removed.
9.4. Front panel installation
(1) First,
fi
t the lower part of the front panel, and insert top and bottom hooks. (Three
top sides)
(2) Attach the 6 screws.
(3) Attach the intake grille.
Top holes (two sides)
Top hole (center)
Top hook (center)
Front panel
Indoor unit
Top hooks (two sides)
Wall hook bracket
Front panel
Push
[
▲
] mark
Screws
(6 position)
Push
Front panel
Front panel
Bearing
Mounting shaft
Intake grille
Intake grille
Knob
CAUTION
Install the front panel and INTAKE GRILLE securely. If installation is imperfect,
the front panel or INTAKE GRILLE may fall off and cause injury.
9318739084_IM.indb 6
9318739084_IM.indb 6
9/27/2012 1:43:54 PM
9/27/2012 1:43:54 PM
