Fujitsu AOT13PNA, Operating Manual

Page: 3 / 19

– 57 –
NAME OF PARTS
Fig. 1 Indoor Unit
e
Remote Control Signal Receiver
u
SWING Indicator Lamp (orange)
i
Intake Grille (Fig. 4)
o
Air Filter
!0
Air Flow Direction Louver
!1
Right-Left Louvers
(behind Air Flow Direction Louver)
!2
Drain Hose
!3
Power Supply Plug
!4
Power Supply Cord
!5
Air Cleaning Filter (optional)
q
Operating Control Panel (Fig. 2)
w
MANUAL AUTO button
r
Indicator lamps (Fig. 3)
t
OPERATION Indicator Lamp (red)
y
TIMER Indicator Lamp (green)
• If the TIMER Indicator Lamp flashes when
the timer is operating, it indicates that a fault
has occurred with the timer setting (See
Page 70 Auto Restart).
Fig. 6 Remote Control Unit
@0
SLEEP button
@1
MASTER CONTROL button
@2
SET TEMP. / SET TIME button ( / )
@3
Signal Transmitter
@4
TIMER button
@5
FAN CONTROL button
@6
START / STOP button
@7
AIR FLOW DIRECTION button
@8
SWING LOUVER button
Rear side (Fig. 7)
@9
TIME ADJUST button
#0
ACL button
(located inside battery compartment)
#1
TEST RUN button
• This button is used when installing the unit,
and should not be used under normal condi-
tions, as it will cause the air conditioner’s
thermostat function to operate incorrectly.
• If this button is pressed during normal opera-
tion, the unit will switch to test operation
mode, and the Indoor Unit’s OPERATION
Indicator Lamp and TIMER Indicator Lamp
will begin to flash simultaneously.
• To stop the test operation mode, press the
START / STOP button to stop the air condi-
tioner.
Fig. 5 Outdoor Unit
!6
Intake Port
!7
Outlet Port
!8
Pipe Unit
!9
Drain port (bottom)
#2
Remote Control Unit Display (Fig. 8)
#3
Transmit Indicator
#4
Clock Display
#5
Operating Mode Display
#6
Timer Mode Display
#7
Fan Speed Display
#8
Temperature Set Display
#9
Timer Set Indicator
$0
Temperature Set Indicator