Fujitsu AOT13PNA, Operating Manual

Page: 12 / 19

– 66 –
SWING OPERATION
To Select SWING Operation
Press the SWING LOUVER button (Fig. 6
@8
).
The SWING Indicator Lamp (orange) (Fig. 3
u
) will
light.
In this mode, the Air Flow Direction Louvers will
swing automatically to direct the airflow both up and
down.
To Stop SWING Operation
Press the SWING LOUVER button (Fig.6
@8
)
once again.
The SWING Indicator Lamp (orange) (Fig. 3
u
) will
go out.
Airflow direction will return to the setting before
swing was begun.
How to Use the Main Unit Controls
Press the MANUAL AUTO button (Fig. 2
w
)
on the main unit control panel.
To stop operation, press the MANUAL AUTO button
once again.
(Controls are located inside the Intake Grille)
Begin air conditioner operation before performing
this procedure.
MANUAL AUTO OPERATION
Use the MANUAL AUTO operation in the event the
Remote Control Unit is lost or otherwise unavailable.
• The SWING operation may stop temporarily
when the air conditioner's fan is not operating or
when operating at very low speeds.
• The airflow direction can not be adjusted during
SWING operation even when the AIR FLOW
DIRECTION button is pressed.
About Swing Operation
• The SWING range is as follows :
Cooling/Dry mode
Heating mode
• When the air conditioner is operated with the
controls on the Main Unit, it will operate under
the same mode as the AUTO CHANGEOVER
mode selected on the Remote Control Unit
(see page 64).
• During MANUAL AUTO operation, the thermo-
stat is automatically set at a standard tempera-
ture setting (= 24°C).
• The fan speed selected will be “AUTO”, and the
airflow direction will be the standard direction
(cooling: q, heating: y).