2
1
2
1
– 67 –
• Before cleaning the air conditioner, be sure to
turn it off and disconnect the Power Supply Cord.
• Be sure the Intake Grille (Fig. 4
i
) is installed
securely.
• When removing and replacing the air filters, be
sure not to touch the heat exchanger, as person-
al injury may result.
Do not operate with open Intake Grille, as this can
cause accidents.
CLEANING AND CARE
Cleaning the Intake Grille
Open the Intake Grille.
q
Place your fingers at both lower ends of the
grille panel, and lift forward; if the grille
seems to catch partway through its move-
ment, continue lifting upward to remove.
w
Pull past the intermediate catch and open
the Intake Grille wide so that it becomes
horizontal.
Intake Grille
Intake Grille
Knob
Mounting shaft
Intake Grille
Knob
Mounting shaft
Intake Grille
Knob
Bearing
Mounting
shaft
Intake Grille
1
Unlock the Intake Grille.
Hold the Intake Grille with one hand and pull the
Knobs on the right and the left all the way to
unlock the Intake Grille.
Raise the horizontal Intake Grille to remove it.
2
Clean with water.
Remove dust with a vacuum cleaner : wipe the
unit with warm water, then dry with a clean, soft
cloth.
3
Set the mounting shaft of the Intake
Grille into the bearings at the top of the
panel.
q
Pull the Knobs all the way.
w
Hold the grille horizontal and set the left and
right mounting shafts into the bearings at
the top of the panel.
4
Lock the Intake Grille.
Hold the Intake Grille with one hand and push
the Knobs on the right and the left all the way in
to lock the Intake Grille mounting shafts.
5
Close the Intake Grille.
Push the lower edge of the Intake Grille at both
ends and at the center to close it.
6
Summary of Contents for AOT13PNA
Page 18: ...MEMO ...
