En-3
CAUTION
• To prevent malfunction or damage of the remote
controller:
- Place remote controller at where will not be
exposed to direct sunlight or excessive heat.
- Remove batteries if the product is not going to be
used for an extended period.
• Obstacles such as a curtain or wall between the
remote controller and the indoor unit may a
ff
ect the
appropriate signal transmission.
• Do not apply strong shocks to the remote controller.
• Do not pour water on the remote controller.
3.2. Remote controller
When you use the optional remote controller, the appearance
and the operation procedure may di
ff
er.
For details, please refer to the operation manual of each remote
controller.
: The setting must be done while the setting screen is displayed
for each function.
: The button is controllable only when the air conditioner is
operating.
: The instruction is relating to the wireless LAN control.
For Energy saving operation ........ Refer to page 7.
Activates or deactivates the Economy
operation.
Activates or deactivates the Energy saving
program that uses the human sensor.
For Basic operations ..................... Refer to page 5.
Starts or stops the air conditioner operation.
Changes the operation mode.
Adjusts the setting temperature.
For Outdoor Unit Low Noise operation
... Refer to page 8.
Activates or deactivates the Outdoor Unit Low
Noise operation.
Remote controller display
In this section, all the possible indicators are displayed for description.
In actual operation, the display is linked with the button operation, and
only shows the necessary indicators for each setting.
Do not press this button in normal use.
It starts the test run (for use by authorized service personnel only).
NOTES:
If the test run starts unintentionally, press to quit the test
run.
Signal transmitter
Aim at the signal receiver of the indoor unit properly.
• Operating range is approximately 22 ft (7 m).
• [ ] will appear when the signal is transmitted.
• The indoor unit will emit a beep when it receive the signal
properly. If there is no beep, press the button again.
For Min. (Minimum) Heat operation
..... Refer to page 8.
Activates the Min. Heat operation.
9387602098̲OM.indb 3
9387602098̲OM.indb 3
2022/09/26 19:41:38
2022/09/26 19:41:38
