A26361-K879-Z102-3-7619
33
Hardware Installation
Installing/Removing the Rack Model
Ê
Repeat the procedure also for the right telescopic rail and the corresponding
assembly brackets VR and HR.
For mounting the left telescopic rail in the PRIMECENTER Rack, the delivered
support bracket must first be mounted on the rear left support upright. The
bracket must be mounted level with the lower edge of the device.
Ê
Mount the support bracket at the appropriate height on the left rear support
upright as described in the technical manual of the PRIMECENTER Rack.
To fasten the telescopic rails, no flange nuts are necessary since the assembly
brackets are equipped with threaded holes. For adjustment in each case two
plugwashers must be pre-mounted at the support uprights and the support
bracket (see figure 8):
Figure 8: Mounting the plugwashers in the support bracket
Ê
Place the plugwashers (1) in the holes of the support uprights and/or of the
support bracket at the marked attachment points.
I
For better orientation the height units are marked on the support
uprights.
