HDCVR
- 43 -
You can not see these two modes if the Enable button is grey.
Type: You can select trusted site and blacklist from the dropdown list. You can view the IP addresson the
following column.
Start address/end address: Select one type from the dropdown list, you can input IP address in the
start address and end address. Now you can click Add IP address or Add IP section to add
For the newly added IP address, it is in enable status by default. Remove the √ before the item,and then
current item is not in the list.
System max supports 64 items.
Address column supports IPv4 or IPv6 format. If it is IPv6 address, system can optimize it. Forexample,
system can optimize aa:0000: 00: 00aa: 00aa: 00aa: 00aa: 00aa as aa:: aa: aa: aa:aa: aa: aa.
System automatically removes space if there is any space before or after the newly added IPaddress.
System only checks start address if you add IP address. System check start address and endaddress if
you add IP section and the end address shall be larger than the start address.
System may check newly added IP address exists or not. System does not add if input IPaddress does
not exist.
Delete: Click it to remove specified item.
Edit: Click it to edit start address and end address. See Figure 4-62. System can check the IPaddress
validity after the edit operation and implement IPv6 optimization.
Default: Click it to restore default setup. In this case, the trusted sites and blocked sites are both
null.
Note:
If you enabled trusted sites, only the IP in the trusted sites list can access the device.
If you enabled blocked sites, the IP in the blocked sites can not access the device.
System supports add MAC address.
Figure 3-38
