EN_25
H.264 DVR
Motion detected zones will be changed to BLUE Color.
•
USE Numeric button to select Motion Grid. GRAY Will be cleared.
•
Or Use <+> button to select Motion Grid at Front Panel. Running
Man Icon will be activated. <+> button is used for selecting and
cancel. Use <-> button to escape from Grid Menu.
It is also possible to select smaller motion grids for more precise motion
•
detection by using CMS.
Save changes and exit the menu, press [ENTER] button. Then go “RECORD” Menu.
5.
Select “ON” or “OFF” to Enable or Disable motion detection on a per camera, as shown below.
6.
Motion Detected zones
Press the REC button, then Motion recording starts according to configured Recording Quality,
7.
Frame Rate when Motion detected. It will be back to stand-by mode after motion recording
time is end. Camera does not record under normal conditions.
<Note> Motion Duration will be extended if there is another motion detection while motion
recording.
<Note> There may be cases when the recorder’s built-in motion detection function does not
operate properly due to the condition of the input video signal or other factors.
<Note> It is recommended selection of at least 3 motion blocks to get more accurate motion
recording.
